18
Edge Sensors. RF659 Series
RF659 [Revision 2.0.0] 26.06.2018
- Click
View
to open the window for browsing the CMOS signal. The
FormView
window appears. Make sure that the
Level
parameter is set correctly.
- Close the
FormView
window.
- Click the
Disconnect
button.
- Connect to the 2nd channel of the controller: select
Net number of device
– 2,
and click the
Connect
button.
- Repeat the algorithm for the 2nd channel.
- Turn off the controller.
- Disconnect the RS485 converter from the controller.
ATTENTION!
In normal operation, the RS485 converter must be disconnected from the controller. Contacts 6,
7 and 8 of the 8-pin connector must be free.