10
Edge Sensors. RF659 Series
RF659 [Revision 2.0.0] 26.06.2018
To edit the parameter, use the
Up
and
Down
buttons. To set the current signal level
as the parameter value, press
Up
. Display 1 shows the
"LECr.x"
message.
To save the
previous value, press
Down
. Display 1 shows the
"LEUP.x"
message. In order to go to the
main menu, press
Enter
.
To exit the settings menu, press the
Esc
button. You will be prompted to exit without
saving to FLASH by the
"CAnCEL"
message. To save parameters to FLASH, select
"SAUE"
and press
Enter
.
9.5. 'Count direction' parameter
Default count direction is conducted from top down (Fig. a). If necessary, the count
direction can be changed.
Press the
Channel
button and select the channel. The current channel number is
highlighted by LED.
Enter the menu, select
"dIr.x"
using the arrows, and press the
Enter
button in order
to enter the submenu.
To edit the parameter, use the
Up
and
Down
buttons. To set the reverse count
direction, press
Up
. Display 2 shows the
"UP"
message. To set the direct count direction,
press
Down
. Display 2 shows the
"dn"
message. In order to go to the main menu, press
Enter
.
When you set the reverse count direction, the
"DIR"
LED lights up.
9.6. 'Analog output polarity and indication direction' parameter
By default the analog output gives -5V with fully opened receiver (display shows
3.500), and +5V with fully closed receiver (display shows -3.500) (Fig. a) - negative polarity.
If necessary, the polarity of the analog output can be changed (Fig. b).
Press the
Channel
button and select the channel. The current channel number is
highlighted by LED.
Enter the menu, select
"AOP.x"
using the arrows, and press the
Enter
button in
order to enter the submenu.
To edit the parameter, use the
Up
and
Down
buttons. To set the positive polarity of
the analog output (Fig. b), press
Up
. Display 2 shows the
"POS"
message. To set the
negative polarity of the analog output, press
Down
. Display 2 shows the
"nEg"
message.
In order to go to the main menu, press
Enter
.
When you set the positive polarity of the analog output, the
"AOP"
LED lights up.
