RIEXINGER BSM 1000, Руководство по эксплуатации

Страница: 34 / 86

32 6. Setup and activation
4) Connect pneumatic lines (optional)
5) Remove the transport anchors at the foot pedal (optional) and place it right from the control
panel
6) Connect electrical power supply (see Chap. 6.5 on p. 30)
7) Make the connection to the suction (see Chap. 6.7 on p. 31)
8) Grease all blank machine guides (see Chap. 9.5 on p. 62).
9) Install a saw band if it has not yet been installed in the machine BSM 631 / BSM 800 / BSM
1000 (see Chap. 9.4 on p. 60)
10) Check all safety equipment (see Chap. 9.6 on p. 64).
11) Check whether all protective equipment is installed and connected (see Chap. 7.2 on p. 33).
12) Activate the BSM 631 / BSM 800 / BSM 1000 by turning the main switch on (see Chap.
7.3 on p. 33).
Danger!
Running saw band may cause serious severance injury!
l
The machine may only be operated by one person.
l
Before running the saw band, the operator must ensure that no persons are
behind the workpiece or in the danger area.
13) Test to see whether the electrical connection is correct by observing the directional move-
ment of the saw band:
a) If button Control ON is not lightening, then press it.
b) Press Lift UP and move saw band up about 50 cm.
c) On the control paneel press and hold both buttons of the Save Ball with one hand.
d) Release the buttons of the Safe Ball and determine the directional movement of the saw
band.
l
The electrical connection is correct (see Chap. 1.6 on p. 7) if the saw band moves from
the front of the machine to the back.
e) If the saw band moves from the back to the front, the electrical connection must be re-con-
figured (see Chap. 6.5 on p. 30).
14) Finally, make a test cut (see Chap. 7.10 on p. 43).
BSM 631 / BSM 800 / BSM 1000