RIEXINGER BSM 1000, Руководство по эксплуатации

Страница: 32 / 86

30 6. Setup and activation
6) Horizontally align the machine frame lengthwise and across with a water level. The slope of
the machine frame can be adjusted by screwing the machine feet in or out.
7) Ensure that all screw feet are resting fully on the ground.
8) Secure the screw feet with the fitted locknut. This concludes machine setup.
6.5 Connect to electrical power supply
Warning!
Electrocution hazard!
Only professional electricians may connect the machine to the power supply
according to the electro-technological regulations.
Caution!
Loosely laid cables are a tripping hazard!
Lay the power cable to the machine so that it does not pose a tripping hazard.
E.g. cable bridges or connections along the ceiling can be used.
Attention!
Faulty connection values may cause material damage to machine!
Therefore, observe the machine's connection values (see Chap. 3.6 on p. 17).
1) Ensure that the cables that connect the BSM 631 / BSM 800 / BSM 1000 are equipped with
an appropriately dimensioned circuit breaker.
2) Ensure that the phase sequence of the outer cable turns clockwise in the receptacle.
3) Connect the BSM 631 / BSM 800 / BSM 1000 to the power supply by connecting the
machine's plug to a receptacle.
6.6 Establish pneumatic connection (optional)
Caution!
Loosely laid air pressure hoses may pose a tripping hazard!
Ensure that the laid-out air pressure hoses to the machine do not pose a tripping
hazard. E.g. cable bridges or connections along the ceiling can be used.
1) Examine whether the pneumatic connection values at the setup location comply with required
values (see Chap. 3.7 on p. 18).
BSM 631 / BSM 800 / BSM 1000