RIEXINGER BSM 1000, Руководство по эксплуатации

Страница: 44 / 86

42 7. Operation
9) When the workpiece is so long that it falls down without clamping, then you will support the
outstanding workpiece end with suitable supports.
10) If necessary, adjust the length of all clamping devices to the diameter of the workpiece by
loosening the screws, adjust the clamping device and tighten the screws.
11) Set the movable support of the workpiece at the right side of the machine so that the work-
piece is supported as close to the cutting line. Be advised by angel cuts, that the saw band does
not collide with the movable support of the workpiece.
12) Keep your hands away from the moving range of the clamping arms. Clamp the workpiece
by pushing with the foot, the foot pedal bottom of the foot pedal up to the stop, so that it snaps
into place.
l
The clamping arms move down and clamp the workpiece.
13) If necessary, set the space between saw band guide and workpiece (see Chap. 7.9 on p. 42)
14) Support protruding ends of long workpieces that tip down when clamped in.
15) Unlock the emergency-off button .
Remove workpiece from the machine.
1) If the saw band remains below the upper workpiece edge, raise up the saw band about 100
mm higher than the workpiece edge. Use button
Lift up .
2) Press the emergency-off button so no one turns on the machine motor.
3) Open the clamping arms of the quick clamping device completely by pressing with the foot,
the upper foot switch of the foot pedal, so that the lower foot switch returns to its starting posi-
tion.
l
The clamping arms move up an release the workpiece freely
4) Remove the workpiece and offcut from the machine with the help of a suitable lifting device
and possibly another person.
5) Unlock the emergency-off button .
7.9 Space between saw-band guide and workpiece
Attention!
If the blade guides are set incorrectly, this can cause damage to the workpiece
and the machine!
Adjust the saw-band guide before sawing so that they may not collide with the
workpiece during the sawing operation.
BSM 631 / BSM 800 / BSM 1000