RIEXINGER BSM 1000, Руководство по эксплуатации

Страница: 43 / 86

7. Operation 41
Attention!
Sharp pipe edges and saw band may injure the operator!
Always wear protective gloves when loading the machine.
Information!
Important informations about the laser!
l
The used laser is a laser class 1 according to DIN EN 60825-1:2008-05.
The accessible laser radiation is harmless.
Attention!
Before sawing the workpiece with the machine, it must be securely tensioned
with two tension belts.
Damage to the workpiece and the machine may result if the workpiece is not
clamped in or clamped in insufficiently.
Attention!
Tension belts can be damaged or severed during angle cuts if they are placed
in a wrong position.
When applying the belts, make sure that the tension belts are not in the path of
the saw blade.
Loading a workpiece into the machine
1) If the saw band is not raised, raise saw band up about 100 mm higher than the upper work-
piece edge.
2) Press the emergency-off button so no one turns on the machine motor.
3) For the processing of pipes with max. Ø 200 mm mount the V-Support (optional).
4) If not already done open clamping arms completely with foot pedal.
5) Place the workpiece onto the support rolls of the machine with the help of a suitable lifting
device and possibly another person.
6) Push the workpiece ahead as far as possible until the cutting line ist under the saw band.
l
The optical cut indicator shows the cutting line on the workpiece (optional)
7) To clamp the workpiece as close to the sawing postition, loosen the screws and adjust the
right clamping arm and fasten srew again. Be advised by angle cuts, that the saw band does not
collide with the right clamping arm!
8) If the workpiece can not bee safely clamped with minimum two tension belts, rotate the work-
piece by 180 degrees in order to clamp it securely to the longer side. or take a longer workpiece.
BSM 631 / BSM 800 / BSM 1000