Riello SC ACS 160, Руководство пользователя

Страница: 32 / 44

32
the time is accurately set on the controller. Please note that the clock continues to run for about 24 hours if the mains volt-
age is interrupted, and afterward must be reset. Improper operation or an incorrect time may result in data being cleared,
recorded incorrectly or overwritten. The manufacturer accepts no liability for the recorded data!
Daylight saving time
If this function is activated, the controller automatically changes to winter time or summer time (DST, Daylight Savings
Time).
Eco Display Mode
In Eco Display Mode the backlight of the display is switched off if no buttons are pushed for 2 minutes.
b
If a message exists, the backlight does not switch off until the message has been scanned by the user.
Temperature unit
In this menu you can select between the temperature units °C and °F.
Network
If necessary, the network settings of the connected data logger must be set.
Access Control
This menu lets you give up to 4 users access to the data logger. The users that are registered then have access to the
controller or respectively the data logger.
To add a user in the list, select <add user>. Leave the now visible menu open and connect to the address of the connec-
tor or respectively the data logger. Your user name is going to appear in this menu and can be selected and confirmed
with ‘OK’.
Note: You can find the address of the connector or respectively the data logger on the address sticker on the outside of
the casing. Pointers and help on how to establish a connection you can find in the enclosed connect instructions or the
instructions of the data logger. Select a user with ‚OK‘ to grant access.
To revoke access again, choose one of the users from your list and choose <remove user>.
Ethernet
The data logger‘s Ethernet connection settings can be set using this menu.
MAC Address
Displays the individual MAC address of the data logger.
Auto-Configuration (DHCP)
If auto-configuration is activated, the data logger requests IP addresses and network parameters from a DHCP server that
assigns an IP address, subnet mask, gateway IP and DNS server IP. If you deactivate the auto configuration (DHCP), you
will have to make the required network settings manually!
IP-Address
Please refer to the router configuration for the IP address to be set.
Subnet Mask
Please refer to the router configuration for the subnetz mask to be set.
Gateway
Please refer to the router configuration for the gateway to be set.
DNS-Server
Please refer to the router configuration for the DNS server to be set.
CAN bus ID
Here you can see the ID of the controller on the CAN bus.