Riello FAMILY CONDENS 2.5, Инструкция по установке и эксплуатации

Страница: 30 / 88

FAMILY CONDENS IS E
30
If you want to modify the temperature value, increasing or reducing
it in relation to the value automatically calculated by the electronic
card, proceed as follows:
- press the heating temperature adjustment key
. The two digits
will show the number corresponding to the set comfort level (fac-
tory setting)
A
- rotate the encoder A to raise or lower the chosen comfort level (the
two digits will show the 1, +2, etc. or -1, -2, etc., corre-
sponding to the chosen level).
The segment lit up in the heating comet will rise or fall.
The correction range is between - 5 and + 5 comfort levels.
These corrections are very important in the mid-seasons, when the
value calculated by the curve may be too low and the room heating
time therefore too long. When 3 seconds have passed since the last
modification, the value is automatically stored and the display again
shows the value measured instantaneously by the probe.
F - Adjusting the domestic hot water
temperature
MODE A heating only - adjustment not applicable
MODE B (only h storage tank with thermostat) - in this case,
every time the storage tank thermostat makes a heat re-
quest, the boiler supplies hot water for the preparation of
the domestic water. During this operation, the
icon will
flash on the display.
MODE C only h storage tank with probe - to adjust the tem-
perature of the domestic water held in the storage tank,
press button and turn the encoder A: The large digits
will light up on the display, indicating the selected temper-
ature value.
After a few seconds, the display will again show the outlet tempera-
ture actually measured by the boiler probe.
A
G - Temporary switch-off
In the event of a temporary absence, weekends, short journeys and
so on:
- Press
.
The display will visualise the words “ENERGY FOR LIFE” and the
anti-freeze icon.
In this way (leaving the electricity and fuel supplies enabled), the
boiler is protected by the following systems:
Antifreeze
when the boiler water temperature falls to 7°C, the circulator is acti-
vated and, if necessary, also the burner (at the minimum output) to
bring the water temperature back within the safety values (35°C).
The
icon will flash on the display, indicating that the anti-freeze
function is active.
Circulator anti-blocking
Circulator antiblocking: an operation cycle is activated every 24 h.
H - Switching off for lengthy periods
If the boiler is not used for a long period, carry out the following op-
erations:
- Press
. The display will visualise the words “ENERGY FOR
LIFE” and the anti-freeze icon.