RIDGID JobMax R2851, Руководство оператора

Страница: 6 / 24

6 - English
To turn the tool
ON
, depress the switch trigger. To turn it
OFF
, release the switch trigger and allow the tool to come
to a complete stop. The trigger will not operate the power
base unless an accessory head is attached.
NOTE:
A whistling or ringing noise coming from the switch
during use is a normal part of the switch function.
DIRECTION OF ROTATION SELECTOR
(FORWARD/REVERSE/CENTER LOCK)
See Figure 1, page 8.
Set the direction of rotation selector in the
OFF
(center lock)
position to lock the switch trigger and help prevent accidental
starting when not in use.
Position the direction of rotation selector to the left of the
switch trigger for forward movement. Position the selector
to the right of the switch trigger for reverse movement.
NOTE:
The tool will not run unless the direction of rotation
selector is pushed fully to the left or right.
NOTICE:
To prevent gear damage, always allow the tool
to come to a complete stop before changing the
direction of rotation.
INSTALLING/REMOVING ACCESSORY HEAD
See Figure 2, page 8.

Disconnect the power base from the power supply.

Depress the latches on both sides of the power base with
one hand while pulling the head away from the tool with
your other hand.

Place the desired accessory head on the power base and
push until the latches click into position. Pull on the head
to make sure it is securely installed before operation.
NOTE:
The head can be installed at 90° angles to best
suit your application needs.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure to do
so could result in objects being thrown into your
eyes, resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
The use of attachments or accessories not
recommended can result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:

Numerous applications are available depending upon the
accessory installed. Refer to the operator’s manual for
the accessory head to determine available applications
while using that head.
Avoid running the tool at low speeds for extended periods
of time. Running at low speeds under constant usage may
cause the tool to become overheated. If this occurs, cool the
tool by running it without a load and at full speed.
LED LIGHT
See Figure 1, page 8.
The LED light, located above the switch trigger, illuminates
when the switch trigger is depressed. This provides extra
light for increased visibility.
VARIABLE SPEED SWITCH TRIGGER
See Figure 1, page 8.
The variable speed switch trigger delivers higher speed with
increased trigger pressure and lower speed with decreased
trigger pressure.
OPERATION
ASSEMBLY
WARNING:
Do not use this product if it is not completely
assembled or if any parts appear to be missing or
damaged. Use of a product that is not properly and
completely assembled or with damaged or missing
parts could result in serious personal injury.
If any parts are damaged or missing, please call 1-866-539-1710 for assistance.
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended
for use with this product. Any such alteration
or modification is misuse and could result in a
hazardous condition leading to possible serious
personal injury.