12. The 2 pieces of heat shrink supplied in
the kit will hold the linkage together after your
length is determined. To apply the heat shrink
slide one piece over the rubber endlink as far
as it will go on to the rod side. Heat the heat
shrink
with a heat
gun(hair dryer or small torch will work) until it
shrinks down to the rubber. Continue heating
the heat shrink to the rod until secured. Be
sure not to over heat the tubing causing it to
pull from the rubber end.
13. Mount the control panel in a convenient
location. Install the Power Button and Manu-
al Control Rocker into the panel. The Power
Button gets installed into the round hole. The
nut that is on the button is used to attach the
button in the panel. The Rocker Switch goes
into the hole with the notch in it. Align the
tab on the switch with the slot and push the
switch into the hole until it snaps in place.
The rocker will only go into the hole one way.
You can also custom mount the buttons if de-
sired. They both use a 3/4” hole. The hole
for the manual switch will have to have a slot
for the tab
14. Hook the wires up to the manual control
switch as shown in the diagram.
% & !'$
Black Wire -Switch Supply
*& !'+
GREEN
BLACK
BLUE
Page 9
TOP
