Ricoh PRO TF6215, Руководство по эксплуатации

Страница: 103 / 116

• There are two gauges. Make a note of the Lo-1, Hi-1, and P2 pressures indicated by each
gauge.
• To switch between the Lo-1, Hi-1, and P2 indications on a gauge, press the [MODE] button.
• If the transparent protective cover is on the gauge, remove it to access the buttons.
• The pressures you have made a note of are required in order to stop ink discharge.
5. Change the pressures indicated by the pressure gauges as follows.
• Lo-1 = 0.1kPa, Hi-1 = 0.5kPa, P2 = 0.0kPa
• You can switch between the Lo-1, Hi-1, and P2 indications on a gauge by pressing the
[MODE] button. To change the indicated pressure, press the [ ] and [ ] buttons.
• Set the Lo-1 and Hi-1 pressures indicated by both gauges to the same value. Do likewise for
the P2 pressures.
6. Click [Discharge] in the "Ink Discharge/Charge" area.
The carriage moves to the left-side ink receiver, and then ink discharge starts.
Once discharge ends, the message "Discharged" appears. Of the sub tank ink levels indicated at
the lower right of the screen, the sub tank of the discharged ink flashes in red.
M0DTOC1063
7. Next, discharge the ink in the following order. Check 2 colors at a time, specify
"Discharge time (Sec)", and then execute [Discharge].
If the ink configuration is set to "Standard Ink Config"
Cyan and Magenta (Discharge time: 60 sec) Yellow and Black (Discharge time: 60 sec)
Clear and Primer (Discharge time: 60 sec)
If the ink configuration is set to "Double White Ink Config"
Cyan and Magenta (Discharge time: 60 sec) Yellow and Black (Discharge time: 60 sec)
White2 (Discharge time: 30 sec)
If the Machine Is to be Left Unused for a Long Time or If a Power Outage Is Scheduled
101