T
echnical
B
ulletin
PAGE: 62/66
Reissued: 8-Apr-05
Model:
Martini-P1
Date:
2-Mar-05
No.:
RG126002a
13. Connect the PCB harness connector [A] to CN129 of the finisher PCB and to CN600 of
the punch unit PCB.
14. Connect the HP Sensor 2 harness connector [B] to CN130 of the finisher PCB and to
HP Sensor 2.
15. Connect the single end of the hopper full sensor connector cable [C] to the hopper full
sensor on the arm (1 connector, 1 clamp), then connect the other two connectors to
HP Sensor 1 [D] and CN620 [E] of the punch PCB.
NOTE:
No special DIP switch settings are required for this punch unit. The punch unit
sends an identification signal to the machine, so it knows what type of punch
unit has been installed.
16. Slide the hopper [F] into the finisher.
17. Re-attach the inner cover and rear cover.
18. Close the front door and re-connect the finisher to the machine.
B531I007.WMF
B531I008.WMF
[A]
[B]
[C]
[D]
[E]
[F]
