Ricoh G148, Руководство по обслуживанию

Страница: 131 / 537

Transfer Belt Unit
1. Never touch the transfer belt surface with bare hands.
2. Take care not to scratch the transfer belt, as the surface is easily damaged.
3. Before installing the new transfer belt, clean all the rollers and the inner part of the transfer belt with
a dry cloth to prevent the belt from slipping.
Laser Unit
1. Do not loosen the screws that secure the LD drive board to the laser diode casing. Doing so would
throw the LD unit out of adjustment.
2. Do not adjust the variable resistors on the LD unit, as they are adjusted in the factory.
3. The polygon mirror and F-theta lenses are very sensitive to dust. Do not open the optical housing unit.
4. Do not touch the glass surface of the polygon mirror motor unit with bare hands.
5. After replacing the LD unit, do the laser beam pitch adjustment. Otherwise, an SC condition will be
generated.
Charge Corona
1. Clean the corona wires with a dry cloth. Do not use sandpaper or solvent.
2. Clean the charge corona casing with water first to remove NOx based compounds. Then clean it with
alcohol if any toner still remains on the casing.
3. Clean the end block with a blower brush first to remove toner and paper dust. Then clean with alcohol
if any toner still remains.
4. Do not touch the corona wires with bare hands. Oil stains from fingers may cause uneven image
density on copies.
5. Make sure that the wires are correctly between the cleaner pads and that there is no foreign material
(iron filings, etc.) on the casing.
6. When installing new corona wires, do not bend or scratch the wire surface. Doing so may cause
uneven charge. Also be sure that the corona wires are correctly positioned in the end blocks.
7. Clean the grid plate with a blower brush (not with a dry cloth).
8. Do not touch the charge grid plate with bare hands. Also, do not bend the charge grid plate or make
any dent in it. Doing so may cause uneven charge.
3. Replacement and Adjustment
130
3