Changing the Specified Image Area On/Off Home Position Setting
In a new machine, this setting is off. If you change this setting to "On", the image
area that you input (using Function 96; see below) will be used for all of your
transmitted pages, unless you switch off the light under the User Function Key
that you programmed for this feature.
1.
Function 6 0 2 2 2 2 9 1
2. The settings for switch 00 are now
shown on the bottom line of the display.
3. Press
↓
until the settings for switch 03
are shown.
The setting that you need to change is
digit 5.
4. If you wish to change the setting, press
4
.
5. Finish:
Yes Function
Specifying an Image Area
1.
Function 6 0 2 2 2 2 9 6
2. Input the skip length then press
↓
.
You must enter a three digit value.
For example, for 75 mm, input 075.
3. Input the scan length then press
↓
.
You must enter a three digit value.
For example, for 95 mm, input 095.
4. Finish:
Yes
The machine returns to the transmission procedure.
Specified Image Area is available only when you are doing one of the following:
❐
Memory Transmission (including Confidential Transmission and Transfer
Request)
❐
Storing a document for Polling Transmission
❐
Storing an Auto Document
USER PARAMETER PRINT LIST
DEFAULT:
01000000
SWITCH00:
01000000
YES
TO END
Digit 5
0: The home position is "Off". After
transmission, Specified Image Area will
switch itself off.
1: The home position is "On". After
transmission, Specified Image Area will
stay active and the lamp under the
User Function Key will stay lit.
IMAGE AREA
YES
TO END
SKIP LENGTH:
000
MM
SCAN LENGTH:
000
MM
IMAGE AREA
YES
TO END
SKIP LENGTH:
075
MM
SCAN LENGTH:
000
MM
❐
1 inch is 25.4 mm. You must input
the dimensions in mm.
A
D
V
A
N
C
E
D
F
E
A
T
U
R
E
S
ADVANCED FEATURES
TRANSMISSION
119
