If you press Copy, the data in the preceding 100(H) range will be printed.
If you press Start, the data in the next 100(H) range will be printed.
3. Service Report
To print the service report, enter the "Print Reports" mode, press Copy three times, then press Start.
The service report contains the last 5 error communication records and the last 10 error codes.
2-2-4. Change Settings
CHANGE SETTINGS:
1:BITSWITCH 2:OUTPUT LEVEL 3:CLEAR RAM 4:NCU PAR
5:INIT RATE 6:ECHO 7:CABLE EQUALIZER 8:BACK-TO-BACK MODE
1. Bit Switch Programming
To enter this mode, enter the "Change Settings" mode then press Copy once. The entry menu will be printed.
BIT SWITCH 0:00000000/00 1:00000000/00 2:00000000/00
SET BITSWITCH - ENTER 2 ADDRESS BITS: COPY=0 START=1
The upper line of the menu shows the current settings of the bit switches.
If you want to change the setting of a bit switch, enter the bit switch number in two-bit binary code (e.g., press Copy
(0) then Start (1) for bit switch 1), then press Start. The selected bit switch setting will be printed.
BIT SWITCH-1:00000000 ENTER 8 DATA BITS: COPY=0 START=1
Then enter new settings using the Copy and Start keys (e.g., 11110000 = S-S-S-S-C-C-C-C).
Refer to section 4-1 for the bit switch definitions.
BIT SWITCH-1 SET: 11110000 DEFAULT: 00000000
After printing the new settings, the machine returns to the bit switch entry menu.
2. Tx Level Adjustment
To enter this mode, enter the "Change Settings" menu, press Copy twice, then press Start. The entry menu will be
printed.
OUTPUTLEVEL: -9
SET THE OUTPUT LEVEL IN -N DBM: ENTER 4 DATA BITS: COPY=0 START=1
Enter the new tx level (e.g., for -6 dBm, enter 0110 = C-S-S-C)
OUTPUT LEVEL SET -6 DBM DEFAULT: -9 DBM
After printing the new setting, the machine returns to the "Change Settings" entry menu.
3. RAM Clear
To enter this mode, enter the "Change Settings" menu, press Copy three times, then press Start. The following in-
struction will be printed.
TO CLEAR RAM PRESS START
Press Start to erase the RAM data. After the RAM has been all reset to the factory settings or if you pressed any
other key than Start in this step, the machine will return to the "Change Settings" entry menu.
2-5
