Paper and Other Media
12
Envelopes
Paper not supported by this printer
Avoid using the following paper as they are not supported by this printer.
• Paper meant for an ink-jet printer
• Bent, folded, or creased paper
• Curled or twisted paper
• Torn paper
• Wrinkled paper
• Damp paper
• Paper that is dry enough to emit static electricity
Additional cautions
•
Print speed for OHP transparencies is slower than for plain pa-
per.
•
Due to switching modes, the machine will be on standby for
thirty or forty seconds after the job was received.
Printer setup
Press
[
Paper Input
]
menu,
[
Paper Type
]
, and then press
[
Thick Paper
]
on the control panel.
❒
The paper type selected using the printer driver overrides that
selected using the control panel.
Printer driver setup
Click
[
Thick
]
in the
[
Type:
]
list.
Enabled paper feeding tray Any input tray can be used.
❒
Make sure paper is not stacked higher than the upper limit
mark (
T
) inside the tray. Make sure paper is not stacked higher
than the paper guides inside the bypass tray.
Both-sided printing
Not possible
Additional cautions
•
Check the print side is facing up.
•
Check there is no air in the envelopes before loading.
•
For better print quality, we recommend the right, left, top, and
bottom print margins to be at least 20 mm (0.8”) each.
•
Load only one size and type of envelope at a time.
•
Before loading envelopes, flatten their leading edges (the edge
going into the printer) by running a pencil or ruler across them.
•
Some kinds of envelope might cause misfeeds, wrinkles or
print poorly.
•
Print quality on envelopes may be uneven if parts of an enve-
lope have differing thicknesses. Print one or two envelopes to
check print quality.
