2 SafeCom Go Ricoh
D60703-16
15
2
SafeCom Go Ricoh
2.1
Overview
Make sure the SafeCom G3 Server software installation has been completed as
described in the
SafeCom Smart Printing Administrator’s Quick Guide D10600
.
1.
SafeCom Go Ricoh hardware installation:
Newer devices Type F, H, I, J, K, L, N and O (2.2.1).
Legacy devices Type B and C (2.2.2).
2.
Increase heap and stack sizes on Ricoh device (2.3).
3.
Ricoh Java software installation:
Newer devices Type C, F, H, I, J, K, L, N and O (2.4.1).
Legacy device Type B (2.4.2).
4.
SafeCom Go Ricoh software installation (2.5).
5.
Additional configuration (2.6).
2.2
SafeCom Go Ricoh hardware installation
Refer to the appropriate section:
If the device has Java embedded connect the USB SafeCom ID Device to
the device‘s USB port and proceed to section 2.5.
Newer devices Type F, H, I, J, K, L and O (2.2.1).
Legacy devices Type B and C (2.2.2).
2.2.1
Newer devices type C, F, H, I, J, K, L, N and O
Install the VM Card (SD card) that was supplied by Ricoh:
1.
Press the operation switch to turn off power. Wait for the
On
indicator to
go off (stop blinking) and then turn off the main power switch. Disconnect
the power cable.
2.
Locate the printer‘s SD card slots (typically located at the rear of the
printer near the RJ-45 network socket). On some printers you have to
remove a plastic cover first.
3.
Insert the SD card labeled
VM Card
in SD card slot 2 or 3.
Install SafeCom ID Device:
4.
Connect the USB SafeCom ID Device to the device‘s USB port.
Reconnect power:
5.
Connect the power cable. Turn on the main power switch. Press the
operation switch to turn on power.
6.
The printer‘s control panel displays
Please wait…
for 30 seconds.
Proceed to section 2.3.
