Ricoh A151, Руководство по обслуживанию на месте

Страница: 275 / 397

IMPORTANT SAFETY NOTICES
PREVENTION OF PHYSICAL INJURY
1. Before disassembling or assembling parts of the copier and peripherals,
make sure that the copier power cord is unplugged.
2. The wall outlet should be near the copier and easily accessible.
3. Note that the optional anti-condensation heaters are supplied with
electrical voltage even if the main switch is turned off.
4. If any adjustment or operation check has to be made with exterior
covers off or open while the main switch is turned on, keep hands away
from electrified or mechanically driven components.
5. The inside and the metal parts of the fusing unit become extremely hot
while the copier is operating. Be careful to avoid touching those
components with your bare hands.
6. When the development unit, cleaning unit, drum unit, or the DF is
removed from the machine, the upper unit becomes lighter. If the upper
unit is released under this condition, it tends to open very abruptly. The
service engineer might be injured if he is leaning over the machine at
this time. Also, the machine might move due to the shock of the upper
unit opening abruptly. To avoid possible injury or machine damage, hold
the upper unit firmly when opening the unloaded upper unit.
7. Due to variation in the tolerance of the torsion springs, the upper unit
cannot be held at an angle of 16 degrees by itself when the DF is
installed. To avoid possible injury, always use the upper unit stand to
keep the upper unit open.
HEALTH SAFETY CONDITIONS
1. Never operate the copier without the ozone filter installed.
2. Always replace the ozone filter at 80K copy intervals.
3. Toner and developer are non-toxic, but if you get either of them in your
eyes by accident, it may cause temporary eye discomfort. Try to remove
with eye drops or flush with water as first aid. If unsuccessful, get
medical attention.
FSM i A202/A203