GTR207 Installation Manual:
Rev 1b
18
Step 9 - Powering the Motor:
•
Ensure that the outer cover has been fitted and fastened back onto the motor housing.
• Before powering up the motor make sure the gate can travel by hand in manual mode (key unlocked).
• Slide the gate to between the middle of the posts, approximately (see below diagrams).
• Lock the key (key locked) in readiness for automatic mode.
• Plug the power cord from the low voltage power supply into the power outlet.
• Remote controls (Part 5) included in this kit are factory paired ready for use.
Please Note:
• The default setting is opening to the right.
• Press the remote control and the gate will open until the spring limit travel stop hits the spring limit
switch. Press the remote control again and the gate will close.
• Soft start/soft stop function - The GTR207 is set by default to provide the soft start/soft stop function.
We recommend this default position is always maintained.
Your motor is now set up for basic remote control operation. To set further
functions and settings, see pages 21-28
For accessories:
please refer to the relevant accessory
manuals for instructions on wiring them to the GTR207 motor.
