GTR207 Installation Manual:
Rev 1b
13
Step 5 - Drilling Holes for Anchor Bolts:
• Mark the (4) positions for your anchor bolts ready for drilling (refer to Fig 13).
• Remove Mounting plate.
• Using a M12 masonry drill bit, drill holes to a minimum depth of 120mm (Fig 14).
Fig 13
Fig 15
Fig 17
Fig 14
Fig 16
Fig 18
Fig 19
Fig 20
Step 6 - Fitting Mounting Plate & Motor:
•
Fit motor mounting plate back into place and fit and tighten anchor bolts (as per figures 15 and 16).
• Fit motor back on mounting plate, ensuring the power cord is positioned into the end slot of the mounting
plate in the direction of the power point, making sure there are no pinch points (as per fig 17).
•
Slide rubber grommet along the power lead and into the end slot of the mounting plate (as per figures 18 & 19).
•
Bolt motor to the mounting plate using the M10 x 50mm bolts with spring and flat washers provided and
tighten as required (as per figure 20).
208mm
135mm
Tighten bolts using
spanner or socket set
Insert the M10 x 50mm bolts
(Part 7d), spring washers,
and flat washers provided
through motor housing and
screw into welded nut on the
baseplate.
Hand-tighten set screws
before final adjustment of motor.
