GTR207 Installation Manual:
Rev 1b
16
Step 8 - Limit Travel Stops:
Included in your gate motor kit are two limit travel
stops (Part 7a) which must be fitted to the gear
racks on your gate to ensure safe operation.
The limit travel stops are designed to set the
desired opening and closing position of your
gate. These limit travel stops are designed to
come into contact with the spring limit switch.
Please note: gates can open and close in
different positions due to different weights of
gates, terrains, slopes (uphill or downhill). The
distance the gate will travel after contacting
the spring limit switch may vary.
Test the spring limit travel stops by moving the gate manually until you hear a click, making sure contact is
made with the spring limit switch on the motor.
To Reset:
When setting new limit travel stop positions please ensure that you turn the power off and then on
again. Turning the power off will reset the limit travel stop memory, allowing for new limit travel stop positions
to be recognised by the motor.
Setting the Limit Travel Stops:
Closed Position:
• Position gate 150-200mm back from
the gate end catch closed position.
This will help in making sure you do
not slam the gate into the end stop/
catch when setting the closed position
under power.
• Fit limit travel stop onto the top of gear
rack at the point where it meets the
spring limit switch on the motor.
• Tighten locking screws.
Open Position:
• Position gate 150-200mm back from
the gate stopper open position. This
will help in making sure you do not
slam the gate into the end stop/catch
when setting the open position under
power.
• Fit limit travel stop onto the top of gear
rack at the point where it meets the
spring limit switch on the motor.
• Tighten locking screws.
Fig 25
Fig 27
Fig 26
