Town Food Service Equipment Company, Inc.
718/388-5650 outside New York State 800/221-5032
RM-55N-R RM-55P-R RM-50N-R RM-50P-R
14
tip
circular
metal disc
washers
dIFFICulTY CAuSE
REMEdY
yellow main burner flame
unit connected to incorrect
check rating plate to confirm unit
type of gas
is connected
to the correct type of gas
black soot collects on
air shutter is closed
adjust/open air shutter
bottom of rice pot
flame lifts off main burner
spillage on main burner or
clean or replace main burner
blockage inside main burner
spillage on main burner
clean or replace main burner
excessive air
adjust/close air shutter
boiling over
too much water
cook with proper amount of water, and
refer to
RiCe pRepARATiON
on page 10
pot interior turns gray
rice pot hasn
’
t been cleaned
thoroughly wash and dry pot
for an extended period of time
pot is discolored by boiling water discoloration will not harm rice pot or
rice but may turn gray
units requiring warranty service must be returned to town Food Service Equipment co., Inc. for repair.
See
gAS COOKeR LiMiTeD WARRANTY
on page 15. call town at 718/388-5650 with model and serial
number and request authorization to return for warranty repair number (RgA #). Non warranty parts are
also available by contacting town.
TROuBlE ShOOTING
____________________________________________________________________________
1. Remove rice pot.
2. locate shut off stem in center of burner.
3. unscrew stem tip.
4. Remove lightweight washers (about
1
⁄
8
” thick) under tip.
5. Reinstall tip.
6. Ensure spring returns to the top of its travel.
figure 1
shut off stem assembly
figure 2
replacing sensing element
1. Remove and invert rice pot.
3. Replace sensing element.
4. Reinstall retaining ring.
2. Remove retaining ring.
iMpORTANT
concave
side of sensing element
must be exposed
sensing element
retaining ring
retaining ring
sensing element
sensing element
If rice cooker shuts off too soon, remove any washers above or below perforated circular metal disc below.
If main burner does not shut off automatically the encased sensor may have to be replaced as pictured below.
