4
Town Food Service Equipment Company, Inc.
718/388-5650 outside New York State 800/221-5032
WA R M
S TA R T
1
Always follow these lighting and shut down instructions when lighting rice cooker. A 5 minute complete
shutoff period is required before lighting or relighting pilot. check for gas leaks before relighting unit.
use soapy water or other suitable leak detector. Rinse off the soapy water after testing.
Notice to Installer—the following must be performed to insure proper operation
1) Remove pot, outer jacket, and base cover.
2) turn gas valve to
ON
position as shown in figure 2 below.
3) gently push on the
#2 COOK
button. It should stop half way down and not engage.
this is a safety feature feature that does not allow accidental start of the main burner unless the pilot
button has already been pushed.
4) Push the left button marked
#1 START
down until the unit clicks, then release it. this is the ignition lever
and should light the pilot. the red button labeled
WARM
button controls the pilot and is hidden by
the
#1 START
button when off. Pushing the
#1 START
button also engages the
WARM
button and
exposes it. It will stay down until pushed up to extinguish the pilot. If the pilot has not lit, repeat until
the pilot lights.
5) If pilot fails to remain lit, refer to
TROuBlE ShOOTING
on page 14.
6) Replace the pot, outer jacket, and base cover in their proper order. With the pilot lit, push the
#2 COOK
button down to its position without water in the pot. the unit should shut off within 3
to 4 minutes. If it fails to shut off, push the
#2 COOK
button up to the
OFF
position and see
TROuBlE ShOOTING
on page 14. If it shuts off normally, add a gallon of water and wait for the
click indicating that the sensor has reset. With the pilot lit, press the
#2 COOK
button again. the rice
cooker should boil the pot dry and then shut off. If it fails to shut off normally, press the
#2 COOK
button up to it
’
s
OFF
position and refer to the
TROuBlE ShOOTING
section on page 14 for
additional causes and remedies.
WARNING
When igniting the pilot, position the jacket window directly over
#1 START
and
#2 COOK
buttons.
use caution when igniting pilot and maintain a safe distance from jacket window (figure 3).
ShuT dOWN
When removing the pot, make sure to push the red
WARM
button up until it clicks and is hidden by the
#1
START
button—it is then in the
OFF
position. A 5 minute complete shut off period is required before
lighting or relighting pilot.
lIGhTING ANd ShuT dOWN INSTRuCTIONS
________________________________________________________________________
C O O K
2
start button
pilot/warmer button
off position
figure 1
main
burner button
jacket window
figure 3
on position
figure 2
