Rice Lake SURVIVOR OTR Series, Руководство по установке

Страница: 8 / 36

SURVIVOR OTR Flattop Truck Scale
4 Visit our website www.RiceLake.com
2.3 Lifting and Handling (Steel Deck)
Deck modules are lifted using four chains or cables attached to the four lift lugs mounted on the top of the weighbridge
( Figure 2-1 ). The lift lugs provide balanced lifting of the modules.
Figure 2-1. Lifting Deck Modules
Loads may disengage from crane scale hook and shackle or lifting eye if proper procedures are not followed.
A falling load may cause serious injury or death.
Never lift more than the crane scale’s assigned Working Load Limit (WLL) rating.
A set of lifting lugs are provided with the scale and shipped on the last module loaded on the truck at the factory.
2.4 Temporary Setting Blocks
When the deck is level with the approaches, the finished scale has a 5 3/4'' clearance between the bottom of the weighbridge
and the concrete foundation. Most installers use setting blocks that are approximately 5 1/2'' high for the initial placement and
connecting of the deck modules. Shims are used to level the scale and raise it flush with the approach bulkhead. Setting blocks
are only used in the corners of the modules where the load cell mounts are installed. The corners that do not have load cell
mount locations do not require setting blocks.
Figure 2-2. Setting Block Measurements (Steel Deck) – 18'' Foundation Profile
When placing modules on setting blocks, place blocks close to the pocket (to allow room for mount).
DANGER
Note
5 1/2"
12 1/4"
17 3/4"
1/4"
18"
Note