Assemble Deck Modules
© Rice Lake Weighing Systems
●
All Rights Reserved
7
3.2 Place and Attach Adjoining Modules B and C
In a scale with more than two modules, the next module is a
B
module (
). If the scale has only two modules, it is a
C
module. Place two 5 1/2'' setting blocks at the corners opposite of the module support pins (load cell mount locations) to support
the
B
module.
Figure 3-5. Module B Installation
Place the
B
module so the module-support pins engage with the pin-connection receptacles of the
A
module and the opposite
end rests on the two setting blocks.
Figure 3-6. Pin and Receptacle Interface
If the pins do not seat squarely in the receptacles, raise the module slightly and reset the module again.
When the
B
module is in place, remove the cables or chains from the module and install any other
B
modules or the
C
module
in a similar manner.
The
C
module is installed in the same way that the
B
module was installed. The end of the
C
module should be approximately
3/4'' from the approach bulkhead.
The weigh module setup is now complete and the scale is ready to be leveled.
Note
Содержание SURVIVOR OTR Series
Страница 1: ...SURVIVOR OTR Flattop Truck Scale Installation Manual PN 53831 Rev F May 29 2020...
Страница 35: ......
