Rice Lake IQ plus 210, Руководство по установке

Страница: 30 / 36

IQ plus 210 Installation Manual
24 Visit our website www.RiceLake.com
5.1.5 Normal Mode Commands
The serial transmit weight data commands (see Table 5-8) transmit data to the serial port on demand. The transmit weight data
commands are valid only in normal operating mode.
5.2 Saving and Transferring Data
Connecting a personal computer to the IQ plus 210 EDP port allows you to save indicator configuration data to the PC or to
download configuration data from the PC to an indicator. The following sections describe the procedures for these save and
transfer operations.
5.2.1 Saving Indicator Data to a Personal Computer
Configuration data can be saved to a personal computer connected to the EDP port. The PC must be running a
communications program such as PROCOMMPLUS
®
.
When configuring the indicator, ensure that the values set for the BAUD and BITS parameters on the SERIAL menu match the
baud rate, bits, and parity settings configured for the serial port on the PC.
To save all configuration data, send the DUMPALL EDP command to the indicator. The
IQ plus 210 responds by sending all
configuration parameters to the PC as ASCII-formatted text.
5.2.2 Downloading Configuration Data from PC to Indicator
Configuration data saved on a PC or floppy disk can be downloaded from the PC to an indicator. This procedure is useful when
a number of indicators with similar configurations are set up or when an indicator is replaced.
To download configuration data, connect the PC to the EDP port as described in
Section 5.2.1 . Place the indicator in setup
mode and use the PC communications software to send the saved configuration data to the indicator. When transfer is
complete, calibrate the indicator as described in Section 4.0 on page 19 .
Calibration settings are included in the configuration data downloaded to the indicator. If the receiving indicator is a
direct replacement for another IQ plus 210 and the attached scale is not changed, recalibration is not required.
When downloading configurations that include changed serial communications settings, edit the data file to place
the serial communications changes at the end of the file. Communication between the PC and indicator will be lost
once the indicator receives settings for baud rate (BAUD parameter) or data bits and parity (BITS parameter) that do
not match those configured for the PC.
Command Description Values
DIGIN1
DIGIN2
Digital input function OFF, ZERO, UNITS, PRINT
Table 5-7. DIG IN EDP Commands
Command Description Response Format
SX Start serial streaming OK or ??
EX Stop serial streaming OK or ??
RS Reset system —
XG Transmit gross weight in displayed units nnnnnn UU
where nnnnnn is the weight value, UU is the units.
XGL Transmit gross weight in pounds
XGK Transmit gross weight in kilograms
XGO Transmit gross weight in ounces
XGG Transmit gross weight in grams
XGC Transmit gross weight in pounds and ounces
XE Query system error conditions nnnnn nnnnn
Table 5-8. Normal Mode EDP Commands
Note