Rice Lake Dyna-Link 2 MSI-7300, Техническое руководство

Страница: 28 / 40

24 MSI-7300 Dyna-Link 2 Technical Manual
• Press to save the number.
• Repeat until all desired numbers have been entered.
5. Press .

displays.
6. Press to enter print control. The last saved control mode will display.
7. Press until the desired print control mode is displayed.
8. Press .

displays. If print control mode is set to

, continue with step 9. If set to

,

or

, go to step 12.
9. Press . The current print weight is displayed.
10. Enter the desired print rate.
• Press to move the cursor position and change the number.
• With the desired number displayed, press to save the number.
• Press to move the cursor to the next position.
• To correct a number, press to go back to numbered that needs to be corrected.
11. When the desired number is displayed, press .

displays.
12. Press twice to return to weigh mode.
6.2 RF Option
The RF options are easily connected and commonly used for gathering weight data after the initial setup of the unit.
For RF operation, the
Dyna-Link 2 uses an 802.15.4 transceiver to communicate with the MSI-8000/8000HD RF
Remote Display.
802.15.4 wireless:
• operates in the 2.4GHz ISM band and does not require the end user to obtain a license.
• can coexist with other 2.4GHz systems, if caution is taken to isolate antennas at least 10' (3 m) from the
Crane Scales and MSI-8000/8000HD equipment.
• Bluetooth
• Wi-Fi
MSI-8000/8000HD based RF systems are peer to peer. For multiple scale connections, the MSI-8000/8000HD acts
as the network coordinator.
6.3 Comm Port Hardware
The Dyna-Link 2 RS-232 comm port is used for software updates, connecting to a remote display, and for
connecting to any RS-232 device.
Table 6-4. Comm Port Hardware
Connector
M12 industrial IP67 rated. An adapter cable (P/N 503363) is required to connect the
Dyna-Link 2 to a computer. This adapter cable converts the Dyna-Link 2 connector to a
standard D9 serial connector.
Data Configuration The data output is fixed at 8-1-N.
Baud Rate
Programmable for 300 to 230.4k baud in eight steps. The bootloader for updating
software is always 38.4k baud.
Handshaking No hardware handshaking is supported XON/XOFF software handshaking is always on.
F1
F1
F1
F2
F1
F1
F2
F1
F2
F1