Rice Lake Dyna-Link 2 MSI-7300, Техническое руководство

Страница: 16 / 40

12 MSI-7300 Dyna-Link 2 Technical Manual
4.4 Setpoints
The Dyna-Link 2 supports two setpoints. Common uses of set points are for warnings or process control. The unit
comes standard with two red LED outputs for a triggered set point. There is an audible output option that is
triggered by setpoint 1.
Table 4-2. Setpoint Parameters
Setpoint is not set.
Greater Than – will trigger the setpoint when the tension exceeds the value
Less Than – will trigger the setpoint when the tension is less then the value
Net/Gross – responds to the tension on the display, net or gross weight.
Gross – responds to gross tension regardless of the display mode.
Total – responds to the totaled weight.
Total Count – responds to the total count (number of samples).
Lift Counter – counts the total number of lifts where the weight exceeded capacity by more than 25%.
To setup a setpoint:
1. Press and simultaneously to enter setup menu.

displays.
2. Press to scroll to

.
3. Press . The current setting displays.
4. Press to scroll to the desired setpoint mode. See Table 4-2.
5. Press to enter the setpoint mode.
6. Press to scroll to the type of tension or weight value the setpoint should be assigned.
7. Press to enter the tension or weight value.
8. Enter the number by:
• Pressing to move the cursor position and change the number.
• With the desired number displayed, press to save the number.
• Press to move the cursor to the next position.
• To enter a decimal point, press , the decimal point will be entered after last number displayed.
• To correct a number, press to go back to numbered that needs to be corrected.
9. When the weight is displayed, press to save and return to previous menu.
10.Press to save and return to the weigh mode.
Parameter Description



Selections for Greater Than and Less Than





F2
F2
F1
F2
F1
F2
F1
F2
F1
F2
F1