Rice Lake DMC-782, Руководство по эксплуатации

Страница: 9 / 36

Installation 5
2.0 Installation
This section describes the procedure for the installation and setup of the DMC-782 coin counting scale.
2.1 Unpacking
Important
Do not turn scale upside down. Always work with scale on its side! Damage to the load cell can occur if
the scale is turned upside down.
1. Immediately after unpacking, visually inspect the DMC-782 coin counting scale to ensure all
components are included and undamaged. If any were damaged in shipment, notify Rice Lake Weighing
Systems and the shipper immediately.
2. The DMC-782 coin counting scale is carefully packed for protection during shipping. After opening the
box, remove all the components. Check the insides of the box carefully to make sure you have all of the
pieces. The package should include the following:
• DMC-782 coin counting scale
• Stainless steel platter
• AC power cord
• Operation manual
3. Remove the bag protecting the scale and the protective film covering the front panel and platter.
4. Seat the stainless steel platter on the platter supports.
5. After ensuring that all parts are present, store the DMC-782 scale box for possible future use.
2.2 Repacking
If the DMC-782 coin counting scale must be returned for modification, calibration or repair, it must be properly
packed with sufficient cushioning materials. Whenever possible, use the original carton when shipping the
DMC-782. Damage caused by improper packaging is not covered by the warranty.
2.3 Setting Up
Place the scale on a solid, level surface away from fans, breezes, and sources of electrical interference.
Level the scale by turning the four adjustable legs located on the bottom of the scale while referencing the bubble
level located on the front of the scale (see Figure 2-1).
Note
To ensure a higher degree of scale stability, turn in all four adjustable legs before leveling. Turn out
adjustable legs to level as needed.