09.
programming
access the programming
mode
quit the programming
mode
09.01. “progr”
09.01.a. key 1
…
key 6
09.01.b. temperature
09.01.c. miscellaneous
09.01.d. diagnostics
09.01.e. sales audit
09.01.f. clock
09.01.g. out of service
the vending machine is programmed by means of parameters
considered standard for the specific configuration required; values
forming the composition of recipes – written in the board memories
– enable the user to dispense drinks without requiring the installer
to set up special programmes; to modify these parameters to adapt
the drinks you have produced, refer to the following; at the end of
the chapter (see 09.06.), a summary table may help the user trace
back all the programming items;
to access the programming mode, open the front door, connect the
programming terminal made available, power on the machine and
insert the service key into the door switch (see 05.12.);
attention
the vending machine is supplied and running to all effects in this
mode of operation; act extremely carefully;
press key “P” of terminal MT1 or the same key as for terminal
MT2-A; the display will show the message:
- “1” to access the programming mode of machine variables;
- “2” to display the drink quantities you have dispensed;
- “3” to dispense on a free basis;
- “4” to dispense water to wash the water circuits;
after having programmed, press “1” and then the key “P” of
terminal MT1 or the same key as for terminal MT2-A; to go back to
the usual operation of the vending machine and to store all
changes you have made; the display will show:
press key “P” of terminal MT1 or the same key as for terminal
MT2-A; press “1” of MT1 or of the machine; the buttons of the MT1
keyboard or of the machine will assume the following functions:
the items are (scroll by means of key “1”):
contains the variables composing selection 1;
…
contains the variables composing selection 6;
to set up the open-top boiler water temperatures;
to programme different options;
to display some machine parameters;
to display the quantity of dispensing cycles you have performed;
to set up the machine clock;
to record any failure that may have occurred;
Key 1
to scroll the items forward
Key 6
to scroll the items backward
Key 2
to scroll the variables of items forward
Key 3
to scroll the variables of items backward
Key 4
to increase the value of the variable on the screen
Key 5
to decrease the value of the variable on the screen
1=PROG. 2=DATA
3=FREE 4=CLEAN
END PROGRAMMING
wait ………………
SALES AUDIT
PROGRAMMING
BUTTON N
PROGRAMMING
TEMPERATURE
PROGRAMMING
MISCELLANEOUS
DIAGNOSTICS
PROGRAMMING
CLOCK
PROGRAMMING
OUT OF SERVICE
MAN1890105 rel. 02 dated 08.03.2017
page no. 24 of 38
www.rheavendors.com tel: 0039 02 966 551 fax: 0039 02 96 55 086 e mail: [email protected]
rheavendors group's sole property
XX micro by
