13.
how to do to:
13.01. empty the drip
tray
13.02. remove the
instant canister
13.03. access to the rear
13.04. remove water
13.05. replace the o-ring
of mixing bowls
13.06. replace the mixer
motor
13.07. replace the
product motor
13.08. determine water
and product times
13.09. programme delays
the drip tray is arranged in its work seat and retained by the
notches in the structure; pull to remove it;
rotate the dispensing slide closure and pull the canister by lifting it
slightly; to reassemble it, insert the rear bush into the motor gear
and the lower pin into the horizontal surface hole; disassemble the
product slides from the canisters by turning them counter
clockwise;
attention
make sure that the power supply cable has been detached
from the mains before
unscrew the three screws shown by the picture
all internal components of the machine can be now accessed;
arrange a bucket beneath the support surface of the machine;
remove the plug intended to close the boiler drain tube and wait
for the water outlet;
remove the internal water tank by lifting it up;
remove the silicone tubes intended to dispense the product; turn
the orange ring nut clockwise; pull the mixing bowl body and
extract the mixer motor; you can now access the w-ring of the
motor shaft; the water inlet gaskets of the mixing bowl and the
mixing bowl gaskets;
remove the silicone tubes intended to dispense the product; turn
the orange ring nut clockwise and pull the mixing bowl body;
unscrew the crosshead screw and extract the motor; the power
supply wires can be removed without any tool;
remove the product canister; access the rear part of the machine;
extract the two small electric cables from the motor, hold the body,
push it to the bottom to release it from the bayonet connection of
the structure; the power supply wires can be removed without any
tool (observe the polarities);
the times specified by table 10.01. can be referred to as the times
functional for the machine and the products to be dispensed;
however, they can be adapted to the capacity of the user’s cups
(by changing “time water N”) and its tastes (by changing “product
N”); please, never forget to make sure that the dispensing time of
the instant product is always lower than the one of corresponding
water;
dispensing starts as soon as the user presses a selection key; the
order in which instant products are poured into the cup depends
upon the values of delays (e.g. the one, the delay value of which is
zero, will be dispensed before the one, the value of which is 40,
dispensed four seconds after the user has pressed the selection
key); pay special attention when programming the delays in
dispensing a product and the water diluting it in the mixing bowl;
except for the instant coffee product, for which just the opposite is
applicable, it is recommended to dispense water before the product
to enable the latter to drop on the water film already present in the
mixing bowl for a better mix;
see 05.06.
see 05.15.
see 05.10. e 05.15.
see 05.16.
see 05.18.
see 05.20.
see 09.01.a.
see 09.01.a.
.
MAN1890105 rel. 02 dated 08.03.2017
page no. 36 of 38
www.rheavendors.com tel: 0039 02 966 551 fax: 0039 02 96 55 086 e mail: [email protected]
rheavendors group's sole property
XX micro by
