RH CGS-240, Руководство пользователя

Страница: 135 / 148

RHS Plateau Software
CGS-240 Manual 6/15/2021
Page 135 of 148
Figure 5.9 Figure 5.10
Figure 5.8
Figure 5.8 shows RHS Plateau with a data set loaded and analyzed.
#1 Data File Window
The figure is shown with a data set loaded. A data set may be loaded by selecting File > Load File and selecting an
existing file from a prestored file location. The data columns within the chosen file may be viewed within the Data
File Window by clicking on the drop-down arrow located to the immediate left of the file name. This is shown
under the file name ‘
hart chub ch1 ref temp ch3 25 ohm sprt.csv
’ . You can use the three buttons
below to select a reference data set, use a manual data set, or choose a UUT data set. For example, select the data
column name (e.g., T1 under file name ‘
hart chub ch1 ref temp ch3 25 ohm sprt.csv
’) , then click
Select as Reference .
#2 Plateaus Tab
The UUT data including the indices of which the plateaus begin and end from the original data set, the mean value
of the UUT, the standard deviation of the UUT, and the reference mean (mean and standard deviation data
displayed is from within the plateau).
#2 Residual Plateaus Tab
The second tab contains the above-mentioned data corrected by the coefficients calculated by selecting the
Calculate button which will be explained further within ‘#5 Utility Settings’. The Plateau(s) window s are shown in
Figure 5.9 and 5.10.