SEM910
Getting Started
The SEM family of wireless Ethernet modems is easy to install and operate. In most instances,
the only installation steps will be setting IP addresses, configuring one SEM as the master and
connecting the antenna, power and Ethernet cable. While the operation of the SEM910/D and
SEM910X/DX is the same, the installation and connection is slightly different. Please refer to the
appropriate section below for connection and installation of your product.
Setting up a pair of SEMs requires the following steps:
•
Enter IP addresses into each SEM
•
Configure one SEM as the Master
The default settings in the SEMs are sufficient to allow connection to Ethernet networks and to
have the slave SEM connect with the master. Other steps you may want to take include:
•
Enter a default route IP address if data is to be sent off the SEM’s subnetwork (See
Ethernet Commands
)
•
Enable one or more of the security features of the SEM (See
Security Commands
)
•
Adjust the RF bandwidth allocation (See
Radio Commands
)
•
Filter out broadcast and multicast packets (See
Bridge Commands
)
•
Change the network number (
See Radio Commands)
Instructions on setting up the SEMs are detailed in the
Configuring the SEM
section of this
manual. Details on the various operating modes and configurations can be found the
SEM
Operation
section.
©
2000- 2004 Cirronet
™
Inc
2
M-910-0003 Rev -
