Rexroth Indramat Mannesmann DKC21.3, Приложение

Страница: 13 / 38

Application Standard Roll Feed
2-7
DOK-SUPPL*-BTV04*ELW**-AW01-EN-P
Drive Information (F4)
This menu can display information from the motor encoder or measuring
wheel encoder. The length and speed of the relevant encoder are speci-
fied. The clear key that is now illuminated can re-set the length back to
„000000,00“.
motor encoder
length + XXXXXX,XXX mm
speed +XXXX,XX rpm
measuring wheel encoder
length +XXXXXX,XXX mm
Fig. 2-7: Drive information
Note: The data referencing the measuring wheel are only displayed
is the measuring wheel mode is set in the ELC parameter
A100.
System I/Os (F5 by Firmware ELC)
The I/O menu can be used to check the current state of the system inputs
and outputs. System inputs support the ELC control and are permanently
assigned. The customer cannot use these for any other purpose. The
following inputs are assigned to the system inputs:
Parameter, manual/automatic, start, stop, jog forward, jog backward.
The customer cannot program system outputs that are status messages.
The following outputs are system outputs:
manual, automatic, interference and run.
Abb028_Syst_EinAusg_en
System inputs
110110
System outputs
0010
F1 = inputs F2 = outputs
Para
Auto.
Start
jog -
jog +
Hand
Auto.
RUN
fault
Stop
Fig. 2-8: System I/Os
A „1“ shows that the relevant input is active and the „0“ displays inactive.
This menu can also be used to display the freely-programmable I/Os.