Revv
Owner’s Manual
7.3
the foot switch to save the setting into
that bank and your done. The LED will
stop flashing verifying that the change
has been saved.
Now every time you press that bank but-
ton, the amp will switch to the configu-
ration you saved to it.
Note: Any change made on the front panel
of the amp will result in a bank LED blink-
ing which means that the current bank
setting is different from that of the amps
new configuration. To save the new setting
press the bank button on the foot switch
(blinking LED), or, to reset the configu-
ration and not keep the change, simply
press another bank button and the change
will NOT be saved.
7.4
7.6
7.7
7.5
Switching Between Modes
The Foot Switch modes can be changed by
holding down button one for two seconds.
Mute & Preset Mode
Mute cannot be saved to a preset bank as it
is always available via button four. (See 7.5)
Memory Reset
The foot switch memory can be cleared
when it is needed. Each of the 4 banks will
be returned to factory defaults. In order to
reset the memory and return the unit to
factory defaults, begin with the amplifiers
power off and the foot switch plugged into
the foot switch jack on the amplifier. Next,
press and hold buttons 1 and 2 down and
turn the power switch to the ON position
on the amplifier. As soon as the foot switch
powers up it will return all memory loca-
tions to factory defaults as long as buttons
one and two were held down properly at
power up.
Mute & the Foot Switch
The amp can be put into mute via the
foot pedal by pressing and holding but-
ton six for 2 seconds in any mode. Once
the amp is muted the LED will flash
until mute is turned off. Mute can be
turned off by pressing button six again
and quickly releasing it.
