Revv
Owner’s Manual
2.7
Mute can also be turned on by holding
down button #4 on the foot switch for
2 seconds. Mute is also MIDI and CC
controllable. (See Section 6)
Note:
It is not possible to program mute
into a foot switch preset bank. Button #4
on the foot switch will control mute in any
foot switch mode. (See Section 7)
Note: Mute is a handy feature that is
not found on many amplifiers today. It is
something that takes time to remember
to use instead of fiddling with volume con-
trols and the standby switch. It is also very
helpful for tuning live and should be taken
advantage of whenever possible.
C - Serial FX Loop Switch
The FX Loop toggle switch turns the
serial
FX loop on and off, as well as in
and out of the signal path.
On and off
is
selected by pushing the toggle switch
up and releasing it quickly,
in and out
is
selected by pushing the toggle switch up
and holding it until the LED flashes.
The
on and off
selection will set the amp
to use the FX loop and activate the FX
loop foot switch button #3 for use. When
the FX loop is not being used it can be
turned off and the foot switch will react
to this condition by flashing the LED
when stepped on.
The
in and out
control of the FX loop
simply does what the foot switch would
do when stepped on, it takes effects in
and out of the signal path. This feature
was added to be able to set the in or out
condition of the FX loop to a preset bank
on the foot switch when the foot switch
is in preset mode (See 7.3), or to control
the in or out function when the foot
switch is not plugged in to the amp.
Note: The Generator is set by default to
start up with the FX Loop turned off. If
you want to bypass the feature and want
the FX loop to turn on automatically at
start up, simply turn the power off on the
amplifier, press the FX Loop toggle switch
up and hold it, then turn the main power
switch to the on position. The FX Loop LED
will flash and immediately turn the loop
on. Now whenever you turn the amplifier
on, the FX loop will also be on and ready
to be put in and out of the signal path as
you wish.
D - Store Switch
The store switch is used to program
MIDI (See section 6) as well as set the
MID channel. (See 6.3)
When the amplifier is powered up, by
pressing the store toggle switch down,
the store LED will begin to flash. At this
point, the amplifier is waiting for a MIDI
program command to be received. Once
received, the current amplifier configu-
ration will then be saved to memory so
that anytime the program command is
received via MIDI; the amp will switch
itself to the saved configuration.
Note:
When in store mode, once a MIDI
program command is received, the LED
will flash quickly then turn off signaling
the user that a program command has
been received and the amps configuration
has been stored to memory.
