Revv
Generator 100w
7.3
Preset Mode
When the foot switch is in preset mode,
each button can then be used to save
amp settings, much like a MIDI program
change command. For example, if you
wanted to save an amp setting like: ch2,
aggression: high, bright: on, fat: on, FX
loop: in, Master volume: 2, you could
save this all to one button! Then every
time you want to use this amp configu-
ration, all you would have to do is press
that one button and the amp would
change to this setting. Each button on
the foot controller can save settings.
Note: When a preset is set into the foot
switch, it will not be lost if power is removed
from the amp. The Generator foot switch
has memory and will retain the settings.
Each button is identical in Preset mode
and will be considered banks. Each bank
can hold an amp preset.
Note: Buttons one and four however, have
2 functions in preset mode. Button one
will switch between the modes (Control
and Preset – See 7.4), and button four
will activate mute in the same way as in
control mode. Holding either button for 2
seconds will activate their other ability.
To set a preset to a bank:
1) Put the foot switch in preset mode
and select the bank you want to save to
(Buttons one through four).
2) Set the amplifier to your desired config-
uration from the front panel of the amp.
3) The bank LED on the foot switch you
have selected will begin to blink stating
a change has been made on the front
panel of the amp.
4) Once you’re finished configuring the
amp, simply press the bank button on
7.2
amp is already in channel one, and
switches between foot pedal modes.
When the button is pushed and released,
it will switch to channel one, if the amp
is already in channel one, it will switch
between clean and crunch amp modes,
and when the button is held down for
2 seconds, the pedal will switch from
control to preset mode and vice versa.
(See 7.4)
Button Two – This button has 2 functions
in control mode, it will switch to chan-
nel two when the amp is not in channel
two, and it will change the aggression
level but only when the amp is already in
channel two.
Note: The foot pedal will not change the
aggression level of channel two unless the
amp is in the channel.
Note: The LED for channel two will change
according to aggression level. Green is low,
Blue is Medium and Red is high. The last 2
colors match those found on the amplifier.
Button Three – This button toggles the
FX loop In/Out. If the FX Loop is not
turned on however, the FX Loop will not
be changed, the LED will flash a few
times to signal this. (See 4.1)
Button Four – This button has two func-
tions in control mode. It is used to switch
between the 2 master volume controls
as well as turn mute on and off. When
the button is pressed and released, it
will change the master volume controls.
When it is held for 2 seconds it will turn
on the mute ability of the Generator and
the LED will flash.
Note: Bright and Fat functions cannot be
changed via the foot switch as they are
considered to be an extension of the EQ.
They can be saved to a bank when in Pre-
set mode however.
