Revv Owner’s Manual - 11
Standby & Power Switch
The Dynamis includes a lush onboard reverb with 3 decay lengths.
These decay lengths & the level of the reverb are independently con-
trollable per channel using the front panel controls.
Upon startup, reverb is engaged with a short decay. To turn reverb on or
off, simply press the reverb toggle switch in the up position. The LED will
turn on or off depending on the setting. To cycle through different decay
options, simply press the toggle switch down towards the decay posi-
tion. The decay options are indicated by LED: short decay (off), medium
decay (blue), long decay (Red).
Note: These levels can be cycled through by holding footswitch button
#4. Reverb can be turned on & off entirely with a single momentary
press of button #4.
The power & standby switches give the amp power from the mains, as
well as high voltage through the circuit. First turn on the power switch &
wait one minute to allow the tubes to warm up. Turn on the standby
switch to the Revv position once you are ready to play.
Note: NEVER power up the Dynamis Head without the proper speaker
load connected, or the Dynamis combo with the speaker disconnected!
Each channel reverb level control is independent & decay se
on/off states are retained for each as long as the amp is powered on.
Note: Reverb settings are also footswitch saveable options should the
foot controller be used in preset mode. See foot controller section of
this manual for more information.
2.5