Revv Owner’s Manual - 33
Note: Any change made on the front panel of the amp will result in a bank
LED blinking which means that the current bank setting is different from
that of the amps new configuration. To save the new setting press the
bank button on the footswitch (blinking LED), or, to reset the configura-
tion & not keep the change, simply press another bank button & the
change will NOT be saved.
Note: To save an FX Loop setting in Preset Mode, the FX Loop Button
must be held for 2 seconds. This will change the state of the FX loop and
then your preset can be saved as with any other amplifier state.
Memory Reset
The footswitch memory can be cleared when it is needed. Each of the 6
banks will be returned to factory defaults. In order to reset the memory &
return the unit to factory defaults, begin with the amplifiers power off &
the footswitch plugged into the footswitch jack on the amplifier. Next,
press & hold buttons 1 & 2 down & turn the power switch to the ON posi-
tion on the amplifier.
As soon as the footswitch powers up it will return all memory locations to
factory defaults as long as buttons one & two were held down properly at
power up.
7.4
