Revv Owner’s Manual - 31
Control Mode
The foot pedal will always power up in control mode. This mode works
similarly to most other foot pedals - it simply controls the functions of the
amp. Here is how the buttons respond in control mode:
Button One
– This button switches to Channel 1 when the amp is not in
Channel 1.
Button Two
– This button has 2 functions in control mode, it will switch to
Channel 2 when the amp is not in Channel 2, & it will change the dynamic
level of Channel 2 when already on that channel. The LED for channel two
will change according to dynamic level.
Button Three
– This button toggles Solo Boost on/off. (On when LED is
illuminated)
Button Four
– This button turns reverb on/off for the currently selected
channel. Reverb decay levels can also be cycled through by holding this
button for approximately 2 seconds at a time.
Button Five
– This button toggles FX Loop on/off. (On when LED illuminat-
ed)
Button Six
– This toggles the amp’s Mute function. (Amp muted when
LED lilluminated)
Note: Bright, Fat, & Contour functions cannot be changed via the
footswitch as they are considered to be an extension of the EQ. They
can be saved to a bank when in Preset mode however.
7.2
