Revere Rescue Racer X 2.0, Руководство по обслуживанию

Страница: 232 / 246

Page A2-24
APPENDIX 2
May/12
9107
SERVICE MANUAL
Page A2-24
Oct/11
APPENDIX 2
SERVICE MANUAL
283
ISO 9650
2.65 Place the painter sachet along the back of the container. Attach the painter
sachet to the H-Pack, using self-adhesive tape.
(a) Ensure the painter cord is in line with and close to the painter
exit hole.
(b) Ensure the free run of painter from the sachet is not impeded.
(c) Adjust the painter sachet extension so that the distance from it
to the painter exit is between 100-150 mm (4”-6”).
2.66 Insert the rubberised end of the painter line through the rubber grommet.
Insert the rubber grommet into the painter exit position of the jig.
2.67 Place the container lid on top, (FIGURE A2-29).
WARNING: WHEN TENSIONING OR CRIMPING STRAPS, THE OPERATOR
MUST STAND TO ONE SIDE OF THE STRAP. PROPER
CLOTHING AND EYE PROTECTION MUST BE WORN. PROPER
FOOTING AND BALANCE MUST BE MAINTAINED WHEN
OPERATING THE EQUIPMENT. USE SHORT HAND STROKES
ONLY DURING TENSIONING.
WARNING: TOO MUCH TENSION WILL BREAK THE STRAP. THIS MAY
RESULT IN INJURY TO PERSONNEL.
CAUTION: FOR ALL LIFERAFTS, IT IS ESSENTIAL THAT CRIMPS
ARE ATTACHED ON THE OPPOSITE SIDE OF THE
CONTAINER TO THE ROLL OF THE LIFERAFT.
CAUTION: ENSURE CORRECT CRIMPING TOOLS ARE USED.
(PLEASE REFER TO IPL FOR CORRECT LIST).
2.68 Obtain the straps and crimps. Tension and crimp each strap as follows:
2.68.1 Adjust the ends of each strap so that the outer most strap end is
facing upwards and is approximately 25 mm (1”) above the rim of the
container, (FIGURE A2-29).
2.68.2 Apply the tensioning tool to the strap at a point half way across the
two rims. Operate the handle to tension the strap until the base of the
tensioning tool rests in the lower container rim. Secure the strap with
a crimp, (FIGURE A2-29), using the crimping tool.