Revere Rescue Racer X 2.0, Руководство по обслуживанию

Страница: 161 / 246

SERVICE MANUAL
Page 839
CHAPTER 8
9107
May/12 Page 839
Feb/11
CHAPTER 8
283
SERVICE MANUAL
ISO 9650
5.51 Attach the identif i cation tube securely to the H-Pack, (FIGURE 839).
5.52 Remove the vacuum valve plug and insert a vacuum line with correct
adaptor.
5.53 Remove the painter sachet from its temporary position on the side of the
container.
5.54 Place the painter sachet along the back of the container. Attach the painter
sachet to the H-Pack, using self-adhesive tape.
5.54.1 Ensure the painter cord is in line with and close to the painter exit
hole.
5.54.2 Ensure the free run of painter from the sachet is not impeded.
5.54.3 Adjust the painter sachet extension so that the distance from it to the
painter exit is between 100-150 mm.
5.55 As the H-Pack is being vacuumed, use a soft rubber mallet to shape the
liferaft so that it will f i t easily within the boundaries of the container,
5.56 If a leak is detected, repair it with the heat sealing tool.
5.57 If the leak cannot be found or repaired, please refer to Chapter 5 Testing and
Trouble shooting, Repair to the H-Pack.
5.58 When the H-Pack has been sealed tight, please refer to Chapter 5 Testing
and Trouble shooting procedures and perform the post operational packing
vacuum test (POPVT), before placing the lid onto the container.
5.59 If the POPVT is successful, wrap the remainder of polythene sheeting
around the outside of the H-Pack. Place any excess on top of the H-Pack,
(FIGURE 839).
WARNING: REMEMBER THE OPERATING MECHANISM IS ARMED.
EXTREME CARE MUST BE TAKEN DURING ALL FOLLOWING
ACTIONS.