Revere Rescue Racer X 2.0, Руководство по обслуживанию

Страница: 135 / 246

SERVICE MANUAL
Page 813
CHAPTER 8
9107
May/12
Page 813
Feb/11
CHAPTER 8
283
SERVICE MANUAL
ISO 9650
2.11 Tie the hauling-in ladders. To carry out this step, the liferaft must be inflated.
2.11.1 10-12 PERSON :
Attach the stretching line from one ladder to the opposite ladder,
using the toggle, (FIGURE 801).
Hauling ladder – Boarding ramp side
(a) Retrieve the correct length of stretching line, (see IPL).
(b) Retrieve the toggle and pull the stretching line, to half way
through both holes of the toggle, (FIGURE 814A).
(c) Insert the free ends of the stretching line through the hauling
in ladder at the doorway. Secure the stretching line using an
overhand knot and tape the flying ends, (FIGURE 814A).
(d) Tie an overhand knot about (200 mm) above the toggle,
(FIGURE 814A).
Hauling ladder – CO
2
cylinder side
(a) Insert the toggle complete with stretching line through the red
webbing-loop, of the hauling-in ladder, (FIGURE 814A).
(b) Pull the stretching line tightly and pass toggle above the knot,
between the stretching lines, (FIGURE 814A).
(c) Stretching line should be left tight. Modify the position of the
knot to adjust the tension.
(d) Secure toggle in place using a rubber band, (see IPL).
Place the rubber band behind the knot. Bring the ends of the
rubber band up and over the edges of the toggle, (FIGURE
814A).