Fig. 5
Fig. 4
Fig. 2
Fig. 1
Fig. 3
Place the vehicle on the fl oor with its rear facing you. Connect the cables from the battery and motor
in the vehicle (Fig. 1). Also ensure before starting that the trim controls for speed and steering (TH. TRIM
and ST. TRIM) are at their middle positions.
Be sure to follow this order when switching on the vehicle:
Set the ON/OFF switch on the side of
the remote control to “ON” (Fig. 2). The two power LEDs on the remote control light up red and green
when the battery is fully charged (Fig. 3). Then set the ON/OFF switch on the vehicle to “ON” (Fig. 4).
Two acoustic signals indicate: the vehicle is ready for operation.
Please note:
When the vehicle and remote control are switched off, the ON/OFF switch on the side of the
vehicle must be set to “OFF” fi rst (see Fig. 4). Only then should you set the ON/OFF switch on the remote
control to “OFF” (Fig. 2). Otherwise you can accidentally give a signal that causes the vehicle to start by
itself, which can lead to signifi cant damage.
Pull the antenna wire through the antenna holder and fasten the end of the wire with the rubber cap (Fig. 5).
Do not cut off the remainder of the antenna wire!
Driving the vehicle
1. GETTING STARTED:
3. VEHICLE CONTROL:
Forward movement
To start the vehicle and move forward, carefully pull the speed control.
To go faster, carefully pull the speed control further.
Braking and reversing
To brake, carefully push the speed control forward until the vehicle stops
or slows down. To reverse, push the speed control further.
2. TRIMMING SPEED AND CONTROLLER:
Correct trimming is crucial for ensuring that the vehicle drives smoothly. It is easy to do, but does require a little patience and a light touch. Please follow these instructions carefully:
If the wheels of the vehicle turn
to the left or right without anyone
turning the steering…
If the vehicle’s wheels turn to the left or right without anyone turning the steering,
turn the steering trim control (ST. TRIM) in the opposite direction until the wheels
are straight and the vehicle moves in a straight line. It is best to trim the steering
while the vehicle is travelling slowly.
If the vehicle moves forwards or backwards without anyone
touching the speed control, turn the speed trim control (TH.TRIM)
in the opposite direction until the vehicle stops by itself.
If the vehicle moves forwards or
backwards without anyone touching
the speed control…
To take left corners, turn the steering control to the left,
assuming the back of the vehicle is facing the driver.
To take right corners, turn the steering control to the right,
assuming the back of the vehicle is facing the driver.
Tip:
The reverse switches for the
speed control (TH) and steering control
(ST) can be used to reverse the
function of the respective controls.
The settings should only be changed
while the vehicle and remote control
are switched off.
English
backwards without anyone tou
the speed control…
If th
to th
If the vehicle’
l s w
turn the steering
are straight and t
hil th
hi l
Forward m
tart the
e
vehicle and move
v forward, c
go faster, carefully pull the speed con
Braking and
eels of the vehicle turn
or right without anyone
ng the steering…
g
g
rn to the left or right without anyo
ntrol (ST. TRIM) in the opposite dir
cle moves in a straight line. It is b
i t
lli
l
l
he whe
he left o
turnin
heels tur
u
trim con
the vehic
i t
l
left corners, turn the steering control t
ng the back of the vehicle is facing the
,
y p
p
, p
To take r
e
e
ight corners, turn
n
n
the steering
assuming the back of the vehicle is fa
8
