REV BW 1000 PS, Монтаж и эксплуатация

Страница: 11 / 24

11
Failure Remedy
BW 1000 PS does not switch on
Manual switch or fuse off Switching on
Daylight setting set on dark Adjust the settings
Feed line interrupted Check and repair
Detecting range adjusted incorrectly Control range, pass through detecting range,
control function, eventually by approaching
the hand
Dirty lense Please clean the lense
Light does not function although the BW 1000 PS switches
Incandescent lamp respectively Changing of the lamp, respectively
appliance
appliance faulty
Feed line interrupted Check and repair
Light is on without interruption
Continous movement in the detecting Remove heat resource, wait until the
range switching on for control the lense can be
covered. Adjust the BW 1000 PS again.
Manual switch on position ”ON” Put switch on position ”OFF”
Undesired switching by itself
Switching on after power failure Normal case, light burns the adjusted time
Sunlight influence on the lense Change brightness regulation or protect
BW 1000 PS against the sun
Heat due to reflection from walls etc. Change detecting range or cover the optics
partly
Trees moving in the wind causes the Change detecting range or cover the optics
switching partly
Heat changes because of extractor Change the mounting place
hoods, kitchen window etc.
Inclusion of cars in large distance Reduce range (tilt angle) or cover the optics
for long distance range
Dogs or cats etc. are included in Cover optics in the close range or change
short distance detecting range
Surch for defect