Restube Swim, Инструкция по эксплуатации, Страница: 12 / 27

22
23
WARNING
If the buoy is not positioned correctly in the pocket, correct release is
not guaranteed!
•
Position the folded buoy in the pocket so that the nut on the
trigger mechanism is facing the label with the nut symbol.
>>> The trigger cord must hang out of the pocket.
• Place the packing flap (6) in front of the buoy and align it along
the seam.
• Store the rest of the safety leash in the pocket next to the
cartridge.
>>> Do not store safety leash in the key compartment in the
flap of the pocket!
• Connect the triangular velcro 5f on the trigger cord to velcro 5c
on the flap.
• Close the flap of the pocket.
5. Troubleshooting
Problem Cause Corrective action
Buoy does not fit into the
pocket
Buoy is not fully emptied > Empty buoy completely
Velcro does not close Buoy is not folded correctly
Buoy is not positioned
correctly in the pocket
> Observe packaging in-
structions
>
Nut on the trigger must face
the label with the nut symbol
CO2 cartridge cannot
be screwed in or only
screwed in with much
difficulty
The release lever was not
closed before screwing in
the CO2 cartridge
> Close release lever and
secure with securing clip.
Then screw in new CO2
cartridge
RESTUBE moves around
waist strap
Waist strap not inserted
correctly into the strap po-
sitioner
Velcro 5d and velcro 5e are
not connected
Waist strap not tight
enough
> Insert waist strap cor-
rectly and position pocket
> Fasten waist strap tightly
Trigger is not accessible
or only with much diffi -
culty
Trigger was packed into the
pocket
Wrong position and align-
ment of the pocket on the
body
> Trigger must hang out
from the pocket
> Observe correct position-
ing and alignment of the
pocket on the body: trigger
must be easily accessible!
6. Maintenance, care, disposal
NOTICE
Should you detect any defects during the inspection, please contact the dealer/
manufacturer whether further use of RESTUBE is possible.
>>> info@restube.com
Never attempt to repair RESTUBE by yourself!
Buoy intact? Open the pocket and unfold the buoy. Inflate the buoy firmly using the
oral valve and leave inflated for about 16 hours. If the buoy is still firmly inflated after
this time, it is airtight.
Does the mouthpiece work?
Remove the cap of the oral valve. Plug the back of the
cap into the oral valve. The oral valve must close completely after the cap is pressed
down and pulled out. Put the cap back on.
Are pocket and straps free from damage? Check pocket, straps, buckle
and seams for any damages. The material should not have holes and the tear
strength should not be impaired (e.g., due to frequent, strong sunlight).
Is the CO2 cartridge unimpaired? Replace empty, corroded, or rusty gas cartridges
with a new original RESTUBE-CO2-Cartridge.
NOTICE
Do not place RESTUBE on heater! Do not dry RESTUBE in direct sunlight! Observe
care symbols on waist strap label. Do not use cleaning agents containing alcohol or
solvents! Functional parts (valve, trigger, thread for CO2 cartridge) must be free from
dirt before next use!
• Close oral valve.
• Rinse buoy and bag with clear water.
• Clean with mild commercial detergent or mild soapy water.
• Rinse again with clear water.
• Dry buoy unfolded and hanging.
>>>
For better drying, open pocket.
NOTICE
Protect RESTUBE against direct sunlight. Protect RESTUBE against temperatures above
60°C. RESTUBE must be completely dry before storing. Do not dry in the microwave
or in the oven.
With normal use and Central European climate, the lifespan is 5 years. With special
operating conditions (e.g., long period of use, use in other climate zones, or frequent
use >1 time per week or frequent release), the product must be serviced more often
and the lifespan may shorten accordingly.
RESTUBE swim is intended for about 40 releases.
WARNING
CO2 cartridges can only be disposed of as residual waste if empty! RESTUBE pocket
and straps may be disposed of as residual waste.
ENGLISH