Respironics 920, Инструкция по эксплуатации и обслуживанию

Страница: 15 / 52

7
English
B
. General
The 920 Hand Held Pulse Oximeter is portable and is intended for
attended patient monitoring by trained personnel.
It displays
numerical values for oxygen saturation and pulse rate. Because the
920 Pulse Oximeter has no patient alarms, the user must frequently
observe the SpO
2
and Pulse Rate displays.
1. Connecting the Sensors
Connect the sensor to its 9-pin mating jack on the top of the 920 as
shown in Figure II.
To select a sensor type, refer to Section VI (A). If
additional cable length is necessary, connect the Model 927 Patient
Cable between the sensor and the 920 Pulse Oximeter.
Position the
appropriate sensor on the patient. Refer to Section VI for sensor
positioning information.
Figure II: Connecting sensors to the 920.
2. Turning on the Pulse Oximeter
Turn on the 920 Hand Held Pulse Oximeter by depressing the “

”
button on the front of the pulse oximeter. Refer to Figure III.
When the 920 is powered on, the SpO
2
and
♥
displays will cycle
through the following sequence before displaying valid data values:
•
“ 888 888 ”
•
time saved in memory in hours and minutes
•
software revision number
•
“ - - ”