20
Parameter
Description
Mode
Range
S
ST
T
PAC iVAPS CPAP
Trigger
Set the level of
inspiratory flow above
which the device
changes from EPAP to
IPAP.
Very Low / Low / Med / High /
Very High
Cycle
Set the level of
inspiratory flow below
which the device
changes from IPAP to
EPAP.
Very Low / Low / Med / High /
Very High
Height
Sets the body height
needed for the dead
space determination.
44–100 inches (110-250 cm),
2-inch increments
Mask
Select the type of mask
used by the patient.
Refer to Mask Device
Compatibility List on
www.resmed.com.
Full Face / Nasal / Pillows /
Pediatric
Comfort
Parameter
Description
Mode
Range
S
ST
T
PAC iVAPS CPAP
Ramp Time
Set the ramp time.
Off / 5–45 mins
Ramp Down Enable / disable the
Ramp Down feature.
Off / On
Start
Pressure
Set the pressure at the
start of ramp, up to
treatment pressure.
4–Set pressure, 0.2 cm H
2
O
(0.2 hPa) increments
Start EPAP
Set the pressure at the
start of ramp, up to
minimum treatment
pressure.
3–EPAP, 0.2 cm H
2
O (0.2 hPa)
increments
Climate Ctrl
Available when HumidAir
humidifier is used and
ClimateLineAir heated air
tubing is connected.
Manual / Auto
Tube Temp.
Set the minimum
temperature of air
delivered by heated air
tubing such as
ClimateLineAir.
Off / 60–86°F (16–30°C),
1° increments
Humidity
Level
Set the humidity level.
Off / 1–8
Содержание AirCurve 10 ST-A
Страница 1: ...Clinical guide English...
Страница 9: ...6 The following diagram illustrates these operating modes...