U
O
U
O
The IP address of the RCS server.
Syncmaster
Connectivity status of the SyncMaster. If no SyncMaster is
configured, the state is “Disabled”.
Ethernet
The actual rate used on the wired Ethernet link.
Radio statistics
The figure below shows the radio statistics information. Note
that these statistics are aggregates of the last five seconds and
that they are intended to be used mainly for troubleshooting
purposes. As some types of transmitted data frames have been
removed from this view, the statistics will not give a good picture
of what the actual link throughput is, just what the link
performance looks like. The parameters are described below.
Figure 17 – Link status.
Throughput
The TX and RX throughput is mainly used for troubleshooting
purposes. Increase in injected traffic reflects in an increase of
throughput.
Total packets
The total packets show how many data packets that have been
acknowledged by the remote end over the past 5 seconds. Not
acknowledged frames, management/broadcast frames and control
frames are excluded from the statistics.
Success data
Acknowledged frames over the past five seconds. Retransmissions
are not counted.
Retries
