Renishaw RMI-QE, Руководство по установке

Страница: 20 / 54

RMI-QE installation guide
2.10
RMI-QE basics
Switches SW1 and SW2
Switch SW1 output configuration
CAUTION: When changing the RMI-QE’s DIP switch settings use a suitable implement and take care
not to damage the switch.
NOTE: To gain access to the switches, remove the front cover, (see section 4, “Maintenance” for
further information).
Factory settings are shown.
ON
CAUTION:
When using error or probe SSR in NO mode, a wiring fault could cause loss of error
condition and therefore could result in a non-failsafe condition.
Abbreviations are as follows:
•
NO = Normally Open
•
NC = Normally Closed
PROBE STATUS 1 Low
battery Error
Pulsed NO NO NO
Level NC NC NC
SW1
SW2